Saturday, February 20, 2010

Eco Exit Signs by Jessup



Going green doesn't have to be expensive

The Federal Energy Management Program says that the best available exit sign product uses photoluminescent technology. What’s more, the program directs all federal agencies to not purchase incandescent light bulb or tritium exit signs, and requires facility managers to replace them immediately.

There’s no doubt about it. Buildings today are going green, and you need an easy, economical solution to reduce your carbon footprint. Get the green light with the zero energy, zero maintenance solution – the new, photoluminescent Glo Brite® Eco Exit™ Signs.

By replacing 100 incandescent exit signs in your building with eco-friendly, easy to install Glo Brite® Eco Exit™ Signs, you will save over $3,500 a year in energy costs - while reducing air pollution by almost a half a million pounds of CO2 over the life of the product. Need more proof?

Zero electricity to operate
Zero wiring to run
Zero bulbs or batteries to replace
Zero toxic/radioactive materials
Zero maintenance for 25+ years
Zero problems with safe disposal

FEATURES:

- Zero energy consumption - zero cost, green design

- Zero maintenance - no bulbs, no battery replacement

- Non-toxic, non-radioactive

- No disposal cost

- Designed for surface, flag, ceiling or conduit mounting

- Can be used for both high-level and low-level applications

- Movable if egress paths change

- Thin, low profile construction

- Consistent, uniform illumination

- Visible at 100 feet

- Recyclable

- LEED points qualified

- Approved for outdoor\wet locations


TECHNICAL INFORMATION:


Letter size: 7/8” stroke with 7” height

Background: Black, Red, Green

Illumination: High Visibility Green

Visibility: 100 feet, 75 feet, 50 feet

Directional: (2) Chevron arrows included for easy direction selection

Construction: ABS plastic with photoluminescent panel

Durability: Explosion-proof for areas requiring explosion-proof exit signage


TESTS PASSED:


UL924 Emergency Lighting and Power Equipment Listed through ETL;

Meets NFPA Life Safety Code 101 and OSHA requirements

International Building Code 2009


Installation:


Surface, flag, ceiling or stem mounted (hardware included). Before installation

it must be determined that there is a minimum of 5 Fc of fuorescent, metal halide

or mercury vapor light on the face(s) of the sign at all times during building occupancy.


Applications:


Both high-level and low-level

Listed for outdoor\wet locations

Suitable for Floor Proximity Installation




Visit Sords Electric to view signs and download pdf's.

No comments:

Post a Comment